Don't worry too much about how your welds look at first:
* While you're improving electrode control, you'll be learning more about different welding job situations.
* Plus I'll tell you WHY it's important to have good rod control.
* After you read these tips, THEN you can practice your welding rod control techniques.
* Whether you swing a golf club or a bat, if you don't practice in correct ways, the results can be at least EMBARRASSING!

Let's talk about arc pressure and gravity:
1) Arc pressure is produced by the voltage from the machine as it's pushing the molten metal outwardly.
2) The pressure will vary depending on machine settings, rod size, & the amount of arc gap.
3) Gravity not only effects the direction of the molten metal, but also it's going to try to make your puddle drip.
4) If you're arc welding in a flat position, you mainly just worry about keeping the rod at right angles to the work-pieces, & tilted away from the puddle, to help control the puddle & the slag. (And that will help you to SEE THE PUDDLE!).
5) If you're going to weld in a vertical position, you need to aim the arc up-ward to preheat the metal & to help keep the puddle from dripping.
6) At the same time, in vertical welding, you no longer need to worry about slag, because gravity is keeping it out of the way.
7) For horizontal positions it's a lot the same. Gravity will try to drip the weld, so you aim the arc upwardly.
8) For overhead jobs you keep the rod nearly straight up for the same reasons. You don't want to do any weaving in overhead welding, instead just use straight "stringer" beads.

Pipe welding:
* Pipe welding is rather unique, in that it involves all positions as you go around it. You will gain real electrode control experience in pipe welding!
* Horizontal welding on pipe can be tricky too, because you need to keep changing the rod angle as you go around.
* Save overhead welding practice for last. Get used to ELECTRODE CONTROL & amp settings in the easier welding positions first.

General tips:
* Learn to keep the arc length as steady as possible, plus keep the rod angle steady.
* Weld in a straight a line. This helps to give your welds to look better, and to give them more strength.
* Use both hands to steady the rod. Either place both hands on the rod holder, or one hand on the rod itself, until it gets too short (or until the rod gets too hot).
* Work on a steady speed to keep a uniform puddle shape. An oval shape is good, but don't let it get too pointed. A round shape may be too wide, unless you need a wider or heavier bead for the job you're doing. You'll soon be able to judge that your welding speed is right for the job size & situation.
* Finding a good amperage setting for the job at hand, will help you to concentrate on getting a good weld, & not be fighting sticking rods, or having the rod burn through the work-piece.
* Learn to hesitate slightly at the start of your welds to ensure that the "puddle" forms sufficiently.
* Also pause a bit, at each side of the bead, when you're doing a weave weld, to make sure there is good penetration.

REMEMBER, Don't worry too much about how your welds look at first! Now start practicing!