Using the Clone or Rubber Stamp Tool

• 1). Acquire a digital photo. This can be done either by transferring images from a digital camera or by scanning a photo into your computer.
  
  
• 2). Open the photo in your editing software.
  
  
• 3). Zoom in on the area with the date and time stamp.
  
  
• 4). Select the cloning or rubber stamp tool.
  
  
• 5). Set the area in the photo for the tool to copy. Chose a spot in the photo that resembles what is being blocked by the date and time stamp. For example, if the stamp is blocking part of someone's pants, select a similar area on their pants and copy that.
  
  
• 6). Click on the area of the date and time stamp you want to patch with your copied selection. This should cover it with a duplicate of the area you previously selected.
  
  
• 7). Repeat steps 5 and 6 until you have completely covered the date and time stamp.
  
  

Cropping

• 1). Open the image in your editing software.
  
  
• 2). Click on the object selection tool. In some programs it is referred to as the rectangular marquee tool or rectangular selection tool. The icon is usually shown as a rectangle or square with a dotted outline and is typically located on the standard toolbar.
  
  
• 3). Create a rectangle with the selection tool over the area of the photo you would like to keep. For example, if you have a full-body photograph of a person but would just like to include their face, use the selection tool to select only their face. This is normally done by clicking on the top left corner of where you would like to begin your selection, holding down the left mouse button, and then dragging the marquee at a diagonal, vertically, or to the right until you have the size you desire.
  
  
• 4). Copy your selection and paste it into a new document. It should now be cropped the way you wish, but if you are unhappy with it you may need to try again. Sometimes it takes practice to get the proper area selected.
  
  
• 5). Save the photo.