Assembling Your Swing

• 1). Insert the legs into the chambers on the housing units. When the legs are completely inside the chambers, a clicking sound will occur. Next, move the legs outward until a snap occurs. The snap indicates the legs are locked, double check by twisting the legs.
  
  
• 2). Screw the feet into the bases, ensuring the labeled part of the foot is facing down. There are two bases, one for the front and one for the back. Each base comes with two feet each. The feet have labels, "Front Bottom," and "Rear Bottom."
  
  
• 3). Place a leg tip on top of each screw. This covers the screws and makes the swing level while on the floor. Slide the bases onto the legs of the swing.
  
  
• 4). Lay the swing down with one side of the legs lying on the floor. Attach the swing seat to the housing unit by the hub arms. Screw arms into place on both sides. On each side of the seat pad there is a plastic tab, insert the tabs into the bottom slots of the swing seat. Attach the tabs to the plastic hooks on the back of the seat.
  
  
• 5). Move the swing to upright position. Apply pressure to the swing ensuring that the seat is installed correctly. Secure both mesh sidings into place by sliding them into the arm hub slot.
  
  
• 6). Lay the seat pad on the swing seat. Pull the straps on the swing seat through the seat pad. Slide the seat pad over top and bottom areas to cover the swing seat.
  
  
• 7). Insert the plastic tabs on the seat pad into the bottom slots on the swing seat. Do this for both sides. Attach the tabs to the small plastic hooks on the back of the seat.
  
  
• 8). Push the toy bar, toys facing toward seat, into the slots on each side of the swing. Press firmly until the toy bar locks into place.