How to Reset a Motion Detector
- 1). Reset the burglar alarm system if the motion detector is connected to it. Type your code or PIN into the alarm keypad.
- 2). Look for a reset switch on the motion detector. If there is one, hold it down for 3 to 5 seconds, then release.
- 3). Find the on/off switch on the motion detector. Turn the device off for approximately 30 seconds, then turn it back on.
- 4). Flip the circuit breaker to the home or office building in the area where the motion detector is wired. Leave it off for approximately 30 seconds, then flip the circuit breaker back on.
- 5). Adjust the motion detector sensitivity. According to BobVila.com, you can usually find sensitivity and time delay switches on the base of the device.
Source...