The Anatomy of a Removable Pool Fence Installation
First the installer will inspect the project area.
Then the installer will do the pool fence layout Using customade templates that aide in marking the precise line of the fence,this will indicate the shape of the fence on the surface of the pool deck.
The gate placement is the most important component of the fence layout.
This is usually done in conjunction with where the steps are located to enter and exist the pool, but not always.
Because the gate entrance is such a high traffic area you may choose to install the gate in another area away from your entertaining, lounging, as well as your cooking areas.
Next, using a grease pencil the installer will lay down the final marks that will be cored out ( not drilled ).
Using a high speed coring rig the installer will core out the the holes that will eventually hold the pool fence poles.
When done properly each of the cored holes will have a slight degree of lean either towards or away from the pool and each pole respectfully,this is done to insure the proper amount of tension for the installation of the fence.
Once the holes have been cut and the actual cores have been removed the installer will wash off any sentiment and clear out any debris such as sand, dirt,pebbles or small pieces of the core that were left behind by the coring rig.
Then using a large rubber mallet the pole sleeves are inserted into the holes and seated.
Now the fence is ready to be set into place.
The installer will inspect each pole as well as the weave of each the fence panels making sure that only the finest quality pool fence will be used in your installation.
Next the installer will check the leans and the angles of the fence making the necessary adjustments to insure that the tension will be adequate.
Before each fence section can be connected to each other the gate must be assembled and installed and set into place.
Once the gate is in place the installer will then connect all of the fence sections making sure once again of the proper leans and angles that will set the tension and create the final shape of the fence are in place and are correct.
The fence area will then be inspected and policed of any and all debris, tools, trash and given one more final wash and sweeping to insure a great looking removable pool fence!!!
Then the installer will do the pool fence layout Using customade templates that aide in marking the precise line of the fence,this will indicate the shape of the fence on the surface of the pool deck.
The gate placement is the most important component of the fence layout.
This is usually done in conjunction with where the steps are located to enter and exist the pool, but not always.
Because the gate entrance is such a high traffic area you may choose to install the gate in another area away from your entertaining, lounging, as well as your cooking areas.
Next, using a grease pencil the installer will lay down the final marks that will be cored out ( not drilled ).
Using a high speed coring rig the installer will core out the the holes that will eventually hold the pool fence poles.
When done properly each of the cored holes will have a slight degree of lean either towards or away from the pool and each pole respectfully,this is done to insure the proper amount of tension for the installation of the fence.
Once the holes have been cut and the actual cores have been removed the installer will wash off any sentiment and clear out any debris such as sand, dirt,pebbles or small pieces of the core that were left behind by the coring rig.
Then using a large rubber mallet the pole sleeves are inserted into the holes and seated.
Now the fence is ready to be set into place.
The installer will inspect each pole as well as the weave of each the fence panels making sure that only the finest quality pool fence will be used in your installation.
Next the installer will check the leans and the angles of the fence making the necessary adjustments to insure that the tension will be adequate.
Before each fence section can be connected to each other the gate must be assembled and installed and set into place.
Once the gate is in place the installer will then connect all of the fence sections making sure once again of the proper leans and angles that will set the tension and create the final shape of the fence are in place and are correct.
The fence area will then be inspected and policed of any and all debris, tools, trash and given one more final wash and sweeping to insure a great looking removable pool fence!!!
Source...