How to Install a Symmons Shower Faucet
- 1). Install the hot and cold renewable seat inside the faucet body. These are two round parts that fit under the faucet cartridge. Screw the washer onto the bottom of the cartridge with the cartridge screw and screwdriver.
- 2). Fit the cartridge into the faucet body over the seats. Slide the cap gasket and seat springs over the cartridge rod. Fit the cover over the cartridge rod, but make sure the rod sticks through the cover.
- 3). Place the trim on the faucet body so the cartridge extends through the trim hole. Screw the trim to the wall with a screwdriver using the two trim plate screws. Tighten these screws until the trim plate is firmly against the wall.
- 4). Put the handle onto the cartridge rod. Place the set screw in the handle and screw it tightly to the handle with an Allen wrench. This will hold the faucet handle in place.
Source...