Instructions for How to Make an Airsoft Gun Automatic
- 1). Spread a sheet of newspaper on a table. Tear off the front and back cover from the magazine. Put the front and back cover of the magazine on the newspaper with the short ends facing you.
- 2). Roll one short end of the front cover over to the other short end to form a tube. Put cellophane tape at the top, middle and bottom of the tube to hold it together.
- 3). Repeat this procedure with the back cover of the magazine.
- 4). Insert one end of the front cover tube into one end of the back cover tube. Wrap cellophane tape around the two tubes where they meet to secure them in place.
- 5). Place the long tube made from the magazine covers horizontally on the sheet of newspaper.
- 6). Measure 3 inches from one end of the tube. Put a piece of cellophane tape on the 3-inch mark. Cut a hole through the cellophane tape and the side of the tube with the utility knife.
- 7). Go outside and hold the automatic airsoft gun you have made in your left hand with the hole that is in the side of the tube closest to you facing up.
- 8). Raise the tube to your mouth. Aim the tube at a tree or rock.
- 9). Drop a plastic BB pellet into the hole in the tube. Fire the plastic pellet by blowing a short burst of air into the end of the tube.
- 10
Drop another plastic BB pellet into the hole and fire it from the tube. Continue dropping plastic BB pellets into the hole and firing them using your breath from the automatic firing airsoft-type gun you have made.
Source...