How to Dismantle & Clean a Glock 26
- 1). Remove the magazine by pressing the magazine release located on the left side of the pistol just behind the trigger guard.
- 2). Locate the slide-locks--protruding from both sides of the pistol just above the trigger guard--and pull them down. Simultaneously, pull the slide back approximately 1/10 of an inch and immediately push it forward until it separates from the pistol grip assembly.
- 3). Turn your slide over and remove the spring assembly by lifting it off the step located on the end of the barrel. Remove the barrel from the slide by lifting it out.
- 4). Apply a liquid carbon remover to your brush and brush off your parts. Use your rags to wipe off additional carbon.
- 5). Attach your bore cleaning brush to your cleaning rod, place some carbon remover on the brush and scrub the interior of your barrel.
- 6). Remove the bore cleaning brush from your cleaning rod and use the rod to pass clean patches through your barrel; continue until the patches come through clean.
- 7). Apply a small amount of gun oil to all the weapon parts and reassemble your Glock 26.
Source...