Instructions

• 1). Drill a hole in the middle of your 16-inch saucer. The hole should be large enough for your vinyl tube to pass through. Use sandpaper to smooth out all the edges of the saucer. Repeat the process with your 25-inch pot.
  
  
• 2). Seal all sides of the pot with polyurethane. This is to ensure that no gap is left between the two spheres when put together.
  
  
• 3). Place the drilled saucer just below the 20-inch pot, turning it upside down. Attach them with silicone caulk, making sure that the hole of the pot and saucer are aligned in a straight line.
  
  
• 4). Place the 14-inch pot on top of the upturned saucer and use silicone caulk to hold them together.
  
  
• 5). Pass the vinyl tube through the holes and connect one end to the motor pump.
  
  
• 6). Hide all equipment such as your pump inside the 25-inch pot. Connect the circuit and fill with water. Ensure that all motor circuits are properly wired and connected.
  
  
• 7). Place the orb, or round pond float, on the 14-inch pot. Plug in and start the motor.