How to Wire an Infinity Amp
- 1). Loosen the screw terminals for the power and ground wire connections. These will be marked "12-V +" and "GND" and can be found on the end panel of most Infinity amplifier models. Use a Phillips screwdriver or an Allen wrench, depending on the type of screw employed.
- 2). Slide the bare end of the red power wire into the "12-V +" terminal and tighten the screw to hold the wire in place. Slide the bare end of the black ground wire into the "GND" terminal and tighten the screw to hold the wire in place.
- 3). Loosen the screw terminal marked "REM" that can be found next to the power and ground connections on the end panel of most Infinity amplifier models. Use a Phillips screwdriver or an Allen wrench, depending on the type of screw employed.
- 4). Slide the bare end of the remote turn-on lead wire into the terminal and tighten the screw to hold the wire in place.
- 5). Loosen the screw terminals marked "SPKR" that can be found on the end panel opposite of the power and ground connections on most Infinity amplifier models. Use a Phillips screwdriver or an Allen wrench, depending on the type of screw employed.
- 6). Slide the bare ends of the speaker wires into the terminals and tighten the screw to hold the wire in place. depending on the number of speakers you'll be connecting and the configuration of the amplifier, you'll typically find one, two or four speaker terminal connections. Match the speaker you're connecting to the terminal.
Source...