How to Make an Access Panel

104 9
    • 1). Cut the drywall to reveal the mechanical element you need access to. For a bathtub access panel the pipes or motor may be small and require only a small panel. For an attic or panel you need to pass through, the opening should be larger.

    • 2). Measure and add blocking around the drywall opening. If you have pipes in the wall you should add 2-by-4-inch wood from the closest wall stud to within an inch of the pipes. Screw two horizontal blocks at the top and bottom of your drywall opening and one vertical block along the side of the opening. Use long screws and pre-start the screws before inserting the block into the wall cavity. Repeat for the other side. The objective is to support the drywall where you have cut the opening and give your panel a sturdy spot to attach.

    • 3). Cut 1/4-inch plywood 2 inches larger than the drywall hole in each direction. Attach 1-inch self stick PVC camper mounting tape along the back inside edges of the plywood to create an air seal.

    • 4). Attach the plywood access panel cover to the blocking at each corner and in the center along each side.

Source...
Subscribe to our newsletter
Sign up here to get the latest news, updates and special offers delivered directly to your inbox.
You can unsubscribe at any time

Leave A Reply

Your email address will not be published.