Easy Set Pools

• 1). Spread the ground cloth out completely so it lies flat. Place the liner on top of the ground cloth and spread it flat as well.
  
  
• 2). Inflate the inflatable ring with a manual air pump until it feels firm.
  
  
• 3). Push the black plugs into the filter pump outlets from the inside of the pool until secured completely. Twist the drain cap on the outside of the pool completely.
  
  
• 4). Fill the pool with water to test if the pool is level. If the water appears uneven, drain the pool and level the area before refilling. While filling the pool, push out the liner from inside the pool to smooth out the wrinkles.
  
  

Framed Pools

• 1). Lay the ground cloth out on the ground so it lies flat. Place the liner on top of the ground cloth and lay it flat as well. Allow the liner and ground cloth to sit in the sun for about one hour until they feel warm before assembling.
  
  
• 2). Position a horizontal beam into the sleeve. After centering the beam, attach a T-joint to one end of the beam. Use a connection pin to secure the beam and T-joint together. Continue with all the other beams until you have all installed in the sleeve.
  
  
• 3). Position a vertical leg into the belt loop on the pool liner. The leg bottom should sit inside the white restraining rope. Push the leg top into the T-joint's bottom. Snap the leg into the T-joint's hole by aligning the holes with the pin. Place the end cap on the leg bottom. Continue positioning the other legs until all are installed.
  
  
• 4). Tug on a few of the beams and shake the pool to verify all beams and legs are connected. Check the position of each leg; all should appear straight and upright.