How to Change the Belt on a Eureka 8803A
- 1). Press the handle release lever. Lower the handle all the way to the floor.
- 2). Turn the 8803A vacuum over so the bottom is facing up. Unscrew and remove the four screws located near the four corners of the brush roll cover.
- 3). Roll the vacuum over so it is right-side-up. Lift up and remove the brush roll cover.
- 4). Lift the brush roll and belt out of the 8803A base unit.
- 5). Thread the new belt over the motor shaft. Thread the other end of the belt over the brush roll.
- 6). Place the left end of the brush roll into the base unit. Insert the right end of the brush roll into its mount.
- 7). Twist the brush roll two full turns to work the belt into the center of the brush roll.
- 8). Replace the brush roll cover. Turn the vacuum over. Replace the four screws that hold the cover in place.
Source...