Things You'll Need

Instructions

1

Choose your planting site. Remove any existing plant material and debris.
2

Dig your planting hole at least 4 times the width of the root ball and deep enough so that the root ball is level with the surrounding area.
3

Remove the plant from the container by gently tapping on the ground and easing the plant out of the container. If the Red Twig was purchased with burlap covering the root ball, cut at least half of the burlap off the root ball exposing the roots. Remove any twine or wire.
4

Fill the planting hole with water and allow the soil to absorb. "Watering in" is an important step to ensure that water reaches the plant roots immediately and help prevent shock.
5

Place the shrub in the planting hole and backfill some of the original soil to secure the plant. Make sure the dogwood is straight.
6

Backfill the remaining soil into the planting hole and gently tap down. Water deeply.
7

Spread mulch or other organic material over the entire planting area. At least 2 to 3 inches is required to help control weeds and maintain soil moisture.