How to Stain Mahogany Wood
- 1). Sand the mahogany with 120-grit sandpaper. Make the piece as smooth as possible and remove any pencil marks that served as witness lines as well as any tooling marks from machining.
- 2). Decide whether to close the pores of the wood's grain for a smooth finish.
- 3). Mix the wood filler per the manufacturer's instructions if you've chosen to fill the pores. Paint thinner is typically used for mixing filler to a paste-like consistency.
- 4). Press the filler into the mahogany using a nylon rag and apply against the grain. Work in sections small enough that the wood filler will not dry out before you finish applying filler.
- 5). Wipe with the grain after adding wood filler across the piece.
- 6). Allow the filler to dry for 24 hours before working the mahogany again.
- 7). Sand the piece smooth with 120-grit sandpaper, then follow with a sanding using 150-grit sandpaper.
- 8). Apply wood stain with a staining brush, foam brush or clean cotton cloth. Use caution not to flood the piece with stain, especially if the mahogany was not sealed with a wood filler. Keep a wet edge while wiping stain onto the wood.
- 9). Wait five to ten minutes before using a clean cotton cloth (different than the one used to apply stain) to wipe off excess stain.
- 10
Wipe the piece down with a tack cloth after the stain has had a chance to dry for 24 hours. Apply a protective finish such as polyurethane, varnish, shellac or tung oil.
Source...