How to Use a Radeon TV Tuner
- 1). Install the Radeo TV Tuner. Power down the computer and disconnect all cables in the back. Use a Phillips-head screwdriver to remove the screws that hold down the protective case of the computer.. Remove the case and insert the Radeon TV Tuner into an available PCI card slot. These available slots will be connected to the motherboard (the largest piece of hardware in the computer). The edge of the Radeon TV Tuner will poke out of the exterior of the computer once the installation has completed---this will allow you to connect the antenna or cable to the TV Tuner.
- 2). Attach the coaxial cable of the antenna or cable to the coaxial cable "In" port on the TV Tuner card. Make sure the cable is tightly fastened.
- 3). Reconnect the cables back to the rear of the computer and power it back on. Wait for Windows to complete load and insert the driver installation disk. Follow the prompts and the driver installation will complete.
- 4). Insert the software installation disk. Agree to the license agreement and follow the remaining software prompts to finish the installation.
- 5). Open the program. Select the tuner tab and click on "Channel Scan." The program will now scan over all of the channels which it can access via the antenna or cable connection.
- 6). Change the channels by either clicking the up or down buttons on the display, or you can push the up and down buttons on the keyboard. You can also type in the number of the desired station and hit "Enter." Adjust the volume by clicking the volume button on the display, or by pressing the right or left arrow buttons on the keyboard.
Source...